Happy Tuesday everyone!!! I hope you are having a fabulous week so far! Today I have a fabulous card to share with you! It’s odd that this was the first Holiday card I made this season and yet I have waited this long to share it with you!! This card is also part of my Cut For Christmas Special Offer!!!
I made this card with the Star of Light Bundle (Save 10%) and I loved it so much I put the set back away and moved on to the next set I had. It was like I had made the perfect card and didn’t need to make more. I have since pulled this one back out and played with it some more!! 🙂
I started with a Whisper White card base. Then I took a piece of Dapper Denim cardstock (4″ x 5-1/4″) and brushed it over with the Embossing Buddy to reduce any static before embossing. I used the large swirl image from the Star of Light Stamp Set and inked it up in VersaMark. I stamped at an angle from the left bottom corner up and the top right corner down so that it looks like it is going across your card. After stamping the swirl, pour the Silver Embossing Powder all over it and then heat it with the Heat Tool to set the powder. Remember to focus the heat on one section until it melts and then move it around rather than swinging it all over the entire image. When you do that, it just disperses the heat and takes longer. Once it is all set, you can take a paper towel or your shirt (like me) and wipe over the top to take off an extra powder from the Embossing Buddy! I stamped the greeting from the Star of Light Stamp Set in Dapper Denim in the lower right corner and added this to my card base. Next up, I stamped the large star image from the Star of Light Stamp Set onto a piece of Whisper White and die cut it out with the coordinating Starlight Thinlits. Then I took some of the Metallic Silver Thread and wrapped it around my fingers a few times. I usually do it about 8-10 but I forget about half way through so it can be as many times as you wish! Slide the loops off of your fingers and twist them in the middle to create a figure eight. Now place the loops onto the back of the die cut star and secure in the middle with a Stampin’ Dimensional. Fan out the loops and add more dimensionals securing the loops in the desired location. Now you can add this to the card front and you are all set!
That silver embossing shine and the texture of the metallic thread but makes this card POP! Plus, I always love silver and dark blue whether it be Dapper Denim or Night of Navy. If you would like to make these for your holiday cards, you can get a head start by having me do all of the cutting. Check out my Cut For Christmas offer as this is one of the cards in the selection!!
If you would like to see this in action, check out the Video Tutorial below or click here! Don’t forget to subscribe if you are new and be sure to click the Like button!!!